You're currently on:

PG-10 Profile Gage

Zoom Out
Zoom In

PG-10 Profile Gage

This item is no longer in production and is not available for purchase. It is listed here for reference purposes only.

Item Number: 1101-142

Availability: Discontinued

Quick Overview

All mating joint surfaces of the PG-10 are indexed to each other. Loosen the locking knob(s) and align the two sections to approximately the tangent lines of your profile, and lock in place. (Note: The joints align at 180 degrees and "ratchet" every 20°. The void between each finger array at 180° is 2.2" or 55.8 mm.)
$209.00
Bookmark and Share

Product Description

Folded close to 90 degrees, the PG-10 Profile Gage will take 4 1/2" deep profiles! Imagine taking a reading of a model boat hull or deep crown molding with this!


For simple moldings and depth readings, square the wire fingers of your profile gage by "profiling" a flat surface. Next, either push the tool against your profile or, for extremely delicate profiles it is easier to work the wires to the profile from the backside. The pressure bar keeps the fingers in place to allow tracing. In either case, the results are fantastic. It's important to note that with our articulated profile gages, you do not push your work into the fingers but instead push the steel fingers into the profile.


Write Your Own Review

You're reviewing: PG-10 Profile Gage

How do you rate this product?*
  1 star 2 stars 3 stars 4 stars 5 stars
Overall